马鞍山二氧化碳储罐

注意事项matters need attention
在您购买我公司的设备之际，请接收我们诚挚的谢意。我们严格按标准和工艺进行制造，但由于安装和使用的不当，仍会引起意外事故。本使用说明书所示安全事项是为了您能安全正确的使用本设备，防止您或他人的危害或损害于未然，一旦实施错误的操作方法，其产生的后果均与安全有关。请接受本使用说明书的指导，并注意如下事项：
Please receive our sincere thanks for your purchase of our equipments. We manufacture in strict accordance with standards and craftsmanship, but will still cause accidents due to improper installation and use. The safety instructions in this manual are for the purpose of safe and correct use of this equipment, to prevent the harm to you or others from harm or damage, and once the wrong operation method is implemented, all the consequences arising therefrom are safety related. Please accept the instructions in this manual, and note the following:
1本设备属于特种设备，要设专职人员管理与操作，操作人员要经过培训持证上岗，否则由于误操作和使用，会造成危及生命安全的可能。
The equipment belongs to special equipment, which should be managed and operated by full-time personnel. Operators should be trained and certified to be on duty. Otherwise, it will be possible to endanger life safety due to misoperation and use.
2 本设备的安装、使用及维修应符合JB6898-1997《低温液体贮运设备 使用安全规则》的规定。本设备应放在室外、通风良好的场所。CO2有很强的窒息性，会引起窒息危险，甚至危及生命。
the installation, use and maintenance of the equipment shall conform to the provisions of JB6898-1997 "safe rules for the use of cryogenic liquid storage and transportation equipment". The equipment should be placed outdoors and well ventilated. CO2 has a strong asphyxiation, which can cause choking hazards and even life.
3 本设备贮存的是-40℃的低温液体，管道、阀门冻结堵塞时严禁用重物敲击、火烤或冷水喷淋等方法解冻，应用70～80℃干净无油的热空气、热氮气解冻。
this equipment is to 40 ℃ cryogenic liquid storage, pipe, valves, frozen jams it is forbidden to use heavy percussion, fire, or cold water spray method of thawing, application of 70 ~ 80 ℃ clean hot air, hot nitrogen release without oil.
【产品详情图片】
【变量3】【变量2】【变量1】

维护与检修 Maintenance and repair
【产品详情图片】
1.储罐的使用与维护，应按“压力容器安全技术监察规程”要求和本说明进行。
The use and maintenance of the storage tank shall be carried out according to the requirements of the Pressure Vessel Safety Technical Supervision Regulations and these instructions
2.日常检查与维护 Daily inspection and maintenance
储罐在运行过程中，要经常检查安全阀、压力表、液位计工作是否正常，阀门管路是否有泄漏，外部有无异常现象，发现问题及时处理。
During operation of the tank, check the safety valve, pressure gauge and liquid level meter regularly, whether the valve line is leaking, whether there is any abnormal phenomenon outside, and find the problem to be handled in time.
3.定期校验 Regular verification
3.1安全阀整定压力不大于2.27Mpa，每年至少校验一次，并加铅封，作好记录。
Safety valve setting pressure is not more than 2.27Mpa, at least once a year, and add seals, make a record.
3.2定期检查夹层真空度，未装低温介质的情况下真空度应低于65Pa，装有低温介质的情况下，真空度应低于10Pa为合格。
Regularly check the sandwich vacuum, the vacuum should be less then 65Pa without vacuum medium; with a low temperature medium, the vacuum should be less than 10Pa for the pass.
【产品详情图片】
【标题】

1、操作前的准备 Preparation before operation
【产品详情图片】
1.1 操作者应按本说明书要求及有关文件进行操作。The operator shall follow the instructions and related documents to operate.
1.2正式投入使用前，用干燥的CO2气体对整个系统进行吹除置换，吹除置换所用的气体纯度不低于充装介质的纯度。Formally put into use before the use of dry CO2 gas blowing the entire system replacement, purge replacement gas purity of not less than the purity of the filling
【产品详情图片】
【主变量】【变量3】【变量2】【变量1】

液体的储存 liquid storage
液体二氧化碳的储存属于带压（压力不低于0.8Mpa）储存。储存期间除压力表、液位计、安全阀应投入使用外，其他阀门应处于关闭状态。当储罐压力超过2.1Mpa时，开启V7排气阀降压。但应注意：内罐的压力不得降至低于0.8Mpa，否则将引起液体二氧化碳转变为干冰。
Liquid carbon dioxide storage with pressure (pressure not less than 0.8Mpa) storage. During the storage, the pressure gauge,level gauge, safety valve should be put into use, the other valves should be closed. When the tank pressure exceeds 2.1Mpa, open the V7 exhaust valve buck. However, it should be noted that the pressure inside the tank must not drop below 0.8Mpa, otherwise liquid carbon dioxide will be converted to dry ice.
【产品详情图片】
【标题】

http://zhongjiezhuangbei.com