太原二氧化碳储罐

常见故障的处理 Common fault handling
【产品详情图片】
1.内罐压力异常长高 Inner tank pressure abnormally high
1.1可能是V3回气阀开度过大或阀门失灵，应减小阀门开度或检修阀门。
May be V3 return valve opening is too large or valve failure, should reduce the valve opening or valve repair.
1.2可能是S1、S2安全阀失灵，到启动压力不启动，应检查安全阀。
may be S1, S2 safety valve failure, to start the pressure does not start, check the safety valve.
1.3可能是压力表指示不准确，应校验压力表。
may be pressure gauge indicates inaccurate, should verify the pressure gauge.
2.液位计指示不真实 Level gauge instructions are not true
2.1可能是液位计失灵，应检修液位计。
may be the level gauge failure, should be maintenance level gauge
2.2可能是液位计接头处泄漏，应检修接头连接处，排除泄漏。
It may be a leak at the head of the liquid level gauge. It should repair the connection of the joint and eliminate the leakage
3.蒸发率高，外壳体凝水结霜 High evaporation rate, the outer shell condensate frost
3.1可能是珠光砂未填实或下沉，应补充珠光砂，重新抽真空。
may be unfilled or sinking of pearl sand, pearl sand should be added and re-evacuated.
3.2可能是真空度恶化，应进行真空检漏，重新抽真空。
may be a deterioration of the vacuum, vacuum leak detection should be carried out, re-vacuum.
4.管道阀门液体流动不畅或堵塞 pipeline valve fluid flow or blocked
可能是液体二氧化碳形成干冰的原因造成，应停止使用，用热空气加温管阀至畅通为止。May be caused by the formation of dry ice, should stop using, with hot air heating pipe valve until smooth.
【产品详情图片】
【标题】

技术参数 Technical Parameters
【产品详情图片】
容 器 类 别 Tank Type：Ⅱ类
介质 Medium：LCO2
设 计 压 力 Design Pressure: 2.2MPa
允许工作压力Max. Allowance working pressure: 2.27MPa
容 积 Volume ：10.5m3
材料Materials：
内胆Liner：16MnDR
外胆 Shell：Q345R
规格Specifications：
内胆 Liner：φ1600×8/8
外胆 Shell：φ2100×8/8
总重 Weight：7600kg
夹层保温材料Sandwich insulation material:
CEP60型珠光砂（含水量≤0.3%） CEP60 pearl sand (water content ≤0.3%)
内胆气压试验 Liner pressure test：
介质 Medium：氮气 Nitrogen 试验压力 test pressure：2.61MPa
内胆内管材料Liner tube materials：S30408
阀门 Valve：低温不锈钢三段式球阀 cryogenic stainless steel three stage ball valve
制造验收标准 manufacturing accept standards：
According to GB/T 18442-2011 Stationary vacuum insulated cryogenic pressure vessel
TSG 21-2016 Safety technical supervision procedures for fixed pressure vessels
【产品详情图片】
【变量3】【变量2】【变量1】

1、高纯二氧化碳主要用于电子工业，二氧化碳激光器、检测仪器的校正气及配制其它特种混台气，在聚乙烯聚合反应中则用作调节剂。
2、固态二氧化碳广泛用于冷藏奶制品、肉类、冷冻食品和其它转运中易的食品，在许多工业加工中作为冷冻剂，例如粉碎热敏材料、橡胶磨光、金属冷处理、机械零件的收缩装配、真空冷阱等。
3、气态二氧化碳用于碳化软饮料、水处理工艺的pH控制、化学加工、食品保存、化学和食品加工过程的惰性保护、焊接气体、植物生长剂，在铸造中用于硬化模和芯子及用于气动器件。
还应用于杀菌气的稀释剂（即用氧化乙烯和二氧化碳的混台气作为杀菌、杀虫剂、熏蒸剂，广泛应用于医疗器具、包装材料、衣类、毛皮、工厂、文物、书籍的熏蒸）。
4、液体二氧化碳用作致冷剂，飞机、和电子部件的低温试验，提高油井采收率，橡胶磨光以及控制化学反应，也可用作灭火剂。
5、超临界状态的二氧化碳可以用作溶解非极性、非离子型和低分子量化合物的溶剂，所以在均相反应中有广泛应用

注意事项matters need attention
在您购买我公司的设备之际，请接收我们诚挚的谢意。我们严格按标准和工艺进行制造，但由于安装和使用的不当，仍会引起意外事故。本使用说明书所示安全事项是为了您能安全正确的使用本设备，防止您或他人的危害或损害于未然，一旦实施错误的操作方法，其产生的后果均与安全有关。请接受本使用说明书的指导，并注意如下事项：
Please receive our sincere thanks for your purchase of our equipments. We manufacture in strict accordance with standards and craftsmanship, but will still cause accidents due to improper installation and use. The safety instructions in this manual are for the purpose of safe and correct use of this equipment, to prevent the harm to you or others from harm or damage, and once the wrong operation method is implemented, all the consequences arising therefrom are safety related. Please accept the instructions in this manual, and note the following:
1本设备属于特种设备，要设专职人员管理与操作，操作人员要经过培训持证上岗，否则由于误操作和使用，会造成危及生命安全的可能。
The equipment belongs to special equipment, which should be managed and operated by full-time personnel. Operators should be trained and certified to be on duty. Otherwise, it will be possible to endanger life safety due to misoperation and use.
2 本设备的安装、使用及维修应符合JB6898-1997《低温液体贮运设备 使用安全规则》的规定。本设备应放在室外、通风良好的场所。CO2有很强的窒息性，会引起窒息危险，甚至危及生命。
the installation, use and maintenance of the equipment shall conform to the provisions of JB6898-1997 "safe rules for the use of cryogenic liquid storage and transportation equipment". The equipment should be placed outdoors and well ventilated. CO2 has a strong asphyxiation, which can cause choking hazards and even life.
3 本设备贮存的是-40℃的低温液体，管道、阀门冻结堵塞时严禁用重物敲击、火烤或冷水喷淋等方法解冻，应用70～80℃干净无油的热空气、热氮气解冻。
this equipment is to 40 ℃ cryogenic liquid storage, pipe, valves, frozen jams it is forbidden to use heavy percussion, fire, or cold water spray method of thawing, application of 70 ~ 80 ℃ clean hot air, hot nitrogen release without oil.
【产品详情图片】
【变量3】【变量2】【变量1】

http://zhongjiezhuangbei.com