品牌中杰特装
型号CFL-20/2.16
类型低温储罐
材质16MnDR
适用物料LCO2
1、操作前的准备 Preparation before operation
【产品详情图片】
1.1 操作者应按本说明书要求及有关文件进行操作。The operator shall follow the instructions and related documents to operate.
1.2正式投入使用前,用干燥的CO2气体对整个系统进行吹除置换,吹除置换所用的气体纯度不低于充装介质的纯度。Formally put into use before the use of dry CO2 gas blowing the entire system replacement, purge replacement gas purity of not less than the purity of the filling
【产品详情图片】
【主变量】【变量3】【变量2】【变量1】
充液的操作 filling operation
【标题】
充液分为充液和补充充液。
充液的操作如下:
Filling fluid is divided into the first filling and filling fluid.
The first filling operation is as follows:
2.1.1 储罐吹除置换干净达到要求后,将充液管线与储罐的充液接头连接,液位计组合阀处于平衡状态准备充液。
After the tank blows off to replace the cleanliness meets the requirements, the filling liquid line is connected with the liquid filling joint of the tank, and the liquid level gauge combination valve is in an equilibrium state to be filled.
2.1.2充入与液体二氧化碳纯度相同的气体,使罐内压力达到0.8 Mpa以上,方可进行充液。 filled with the same purity of liquid carbon dioxide gas, the tank pressure reached 0.8 Mpa above, before filling.
2.1.3 将充液管线接通槽车,先开启V5残液阀,排出管线内的杂质气体后,再开启V1进液阀和V7排气阀,V8液位计组合阀处于全开状态,显示液位计读数进行充液。
The filling liquid line connected tanker, first open the V5 raffinate valve, exhaust gas impurities within the pipeline, and then open the V1 inlet valve and V7 exhaust valve, V8 level gauge combination valve is fully open state, Display level meter readings are filled.
2.1.4 在充液过程中,当液位计指示液位接近标定值时,可间断开启V4充满指示阀,如有液体喷出,应立即停止充液,关闭V4充满指示阀。
During the filling process, when the liquid level gauge indicates the liquid level approaches the calibration value, the V4 may be intermittently opened to indicate the valve. If any liquid is ejected, liquid filling should be stopped immediately and the V4 valve should be closed.
2.1.5关闭V1进液阀和V7排气阀,打开V5残液阀,拆下充液管线,充液结束。
补充充液的操作与充液的操作方法相似,不同点是补充充液时一开始就可以大量充液。
Close the V1 inlet valve and the V7 exhaust valve, open the V5 residual valve, remove the filling line, and fill with liquid.
The procedure for replenishing the priming solution is the same as for the first priming procedure, except that the priming solution can be replenished extensively from the beginning.
【产品详情图片】
【标题】
【标题】
【主变量】【变量1】
【产品详情图片】
低温储罐是我公司七大事业中心之一---深冷容器事业中心主要产品,具有有5-200立方米立、卧式低温液体储罐(液化天然气储罐LNFG,液氧储罐LO2,液氮储罐LN2,液氩储罐LAr2,二氧化碳储罐LCO2)。
低温储罐是贮存低温液化天然气、液氧、液氮、液氩、液态二氧化碳等介质的贮存压力容器。低温储罐为双层固定真空粉末绝热储罐(贮槽)。液化天然气、液氧、液氮、液氩内胆原料选用不锈钢,二氧化碳储罐为16MnDR),外胆原料为Q345R或许16MnR。外表防腐涂层选用喷砂除锈、吹扫、喷涂等工艺,同时选用了挪威进口佐敦涂料,保证5年油漆不脱落。
【产品详情图片】
低温储罐在内容器与外容器之间的夹层选用热态下的珠光砂为绝热材料并抽真空,以到达的绝热作用。
低温储罐产品主要用于液化天然气、液氧、液氮、液氩以及二氧化碳等气体的低温液态存储。1立方米液体能够代替130支气体钢瓶。它能够替代每天用气瓶往返运输,节约很多的人力物力。
【产品详情图片】
【变量3】【变量1】
注意事项matters need attention
在您购买我公司的设备之际,请接收我们诚挚的谢意。我们严格按标准和工艺进行制造,但由于安装和使用的不当,仍会引起意外事故。本使用说明书所示安全事项是为了您能安全正确的使用本设备,防止您或他人的危害或损害于未然,一旦实施错误的操作方法,其产生的后果均与安全有关。请接受本使用说明书的指导,并注意如下事项:
Please receive our sincere thanks for your purchase of our equipments. We manufacture in strict accordance with standards and craftsmanship, but will still cause accidents due to improper installation and use. The safety instructions in this manual are for the purpose of safe and correct use of this equipment, to prevent the harm to you or others from harm or damage, and once the wrong operation method is implemented, all the consequences arising therefrom are safety related. Please accept the instructions in this manual, and note the following:
1本设备属于特种设备,要设专职人员管理与操作,操作人员要经过培训持证上岗,否则由于误操作和使用,会造成危及生命安全的可能。
The equipment belongs to special equipment, which should be managed and operated by full-time personnel. Operators should be trained and certified to be on duty. Otherwise, it will be possible to endanger life safety due to misoperation and use.
2 本设备的安装、使用及维修应符合JB6898-1997《低温液体贮运设备 使用安全规则》的规定。本设备应放在室外、通风良好的场所。CO2有很强的窒息性,会引起窒息危险,甚至危及生命。
the installation, use and maintenance of the equipment shall conform to the provisions of JB6898-1997 "safe rules for the use of cryogenic liquid storage and transportation equipment". The equipment should be placed outdoors and well ventilated. CO2 has a strong asphyxiation, which can cause choking hazards and even life.
3 本设备贮存的是-40℃的低温液体,管道、阀门冻结堵塞时严禁用重物敲击、火烤或冷水喷淋等方法解冻,应用70~80℃干净无油的热空气、热氮气解冻。
this equipment is to 40 ℃ cryogenic liquid storage, pipe, valves, frozen jams it is forbidden to use heavy percussion, fire, or cold water spray method of thawing, application of 70 ~ 80 ℃ clean hot air, hot nitrogen release without oil.
【产品详情图片】
【变量3】【变量2】【变量1】
-/gjehec/-
http://zhongjiezhuangbei.com